![]() ![]() We now need to insert or mount the Windows 7 drive.You should now be back at command prompt.Finally type “assign” to have windows assign the drive a mount point.You can also add “quick” after NTFS to perform a quick format. Next we will format the drive with the command “FORMAT fs=ntfs” you could also use FAT32 but I prefer NTFS.Then type “active”, this will mark the partition bootable.Now type “create partition primary”, which will create a new partition.Type “clean” to wipe the partition table.Now run select disk # where # is the number associated with your flash drive.Next run the “list disk” command to get a view of the available devices connected to the machine.At command prompt open diskpart (type diskpart then press enter).I would recommend a 4GB drive, as the Windows DVD ISO is 2.35GBįirst we’re going to open up diskpart to prepare the Flash Disk. The N270 ATOM processor does not support x86_64 (amd64) extensions, so you’re going to want to grab the 32bit version. Your Free for One Year Windows 7 Key and Release Client DVD-ISO can be downloaded from here: This guide will tell you how to acquire Windows 7, prepare a flash drive to install Windows 7, and to acquire the necessary drivers after installation is finished. I figured this would be a good time to make a guide specifically for you in the same situation as I was. I saw a few incomplete guides out there, including the one that I used to install Windows 7 on my eee PC 1000. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |